Usage and Installation Manual for Combination Heat Pump Water Heater
Selection of power supply wiring and air switch:
Power supply type
air
switch
（A）
power supply cord Model
H07RN-F 5G 1.5mm
2
KFRS-9/Na-M 380-415V 3N~ 50Hz 13
Note：
1.The power supply wire must be copper core wire, and the working temperature can not be higher
than limited value.
2.If the length of power supply wire is longer than 15meters, do please increase the section area to
avoid any accident due to over-load.
3. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similar qualified person in order to avoid a hazard.
4. The appliance shall be installed according to national regulations
5. When installing the connection wiring for manual controller, the wire must be put inside a
separate protective sheath to avoid direct sunshine.
Warning!
An all-pole disconnection switch having a contact separation of at least 3mm in all poles
should be connected in fixed wiring
.
！
18
To Next Page
Loading...
