Gree MULTI18HP230V1A - Page 38

38
10) X-Fan
Allows fan to run aer cooling cycle to dry o the coil and inhibit the growth of bacteria and mildew. Works
with “Auto” mode.
11) Turbo Fan
Boost the cooling or heating airow, allowing the unit to reach the preset temperature in the shortest amount of
time.
12) Timer On Button
Press the “Timer-On” button once to set mode on time, press again to save setting. Holding the “+” or “-” button
down will rapidly change the time in 10 minute intervals.
13) Temp Button
Toggles the display between set temperature, indoor temperature and outdoor temperature.
14) Sleep Button
Sets sleep mode function, see owners manual for specic model information
15) Swing Angle Button
Controls the angle of the louvers for the convenient adjustment of airow
16) Timer O Button
Press the “Timer-O ” button once to set mode o time, press again to save setting. Holding the “+” or “-” button
down will rapidly change the time in 10 minute intervals.
17) Light Button
Turns the light on the indoor display on and o.
18) Auto Button (Manual Override) - Located on indoor unit.
In the event the controller is missed placed or the batteries are defective, this will override the remote controller.
If the controller is on, pressing this button will stop it, if it is o, pressing the button will turn the controller on.
When turning the controller on, the swing and light will be on and the unit will run in Auto Mode.
Remote Control Functions
Product Introduction