Gree U-match Series

U-Match Series DC Inverter Service Manual
62
1.2.4 Installing the Suspension Bolts
(1) Using the installation template, drill holes for bolts (four holes) (Figure 3-1-40).
(2) Install the bolts to the ceiling at a place strong enough to hang the unit. Mark the bolt positions
from the installation template. With a concrete drill, drill for 12.7mm (1/2inch) diameter holes (Figure
3-1-41).
(3) Insert the anchor bolts into the drilled holes, and drive the pins completely into the anchor bolts
with a hammer (Figure 3-1-42).
60 to 70mm(2-3/8 to 2-3/4inch)
φ12.7mm(1/2inch)
Drilling position for bolts
Figure 3-1-40 Figure 3-1-41 Figure 3-1-42
1.2.5 Leveling
The water level test must be done after installing the indoor unit to make the unit is horizontal, as
shown below.
Horizontal tester
Figure 3-1-43
1.2.6 The Panel Installation
(1) See the figure below for the relationship of the front panel and the connecting pipe.
Figure 3-1-44