Ultra Heat GMV Multi VRF_Heat Recovery Serial
60
Debugging:
Preheat time of compressor is insufficient
Alarm because ODU quantity is inconsistent
Wrong setting of ODU’s capacity
code/jumper cap
Abnormal communication of converter
Power supply phase sequence protection
Emergency status of compressor
Refrigerant-lacking protection
Wrong address for driving board of
compressor
Emergency status of module
Alarm because valve is abnormal
Rated capacity is too high
Malfunction of pipeline for IDU
Malfunction of pipeline for ODU
The matching ratio of rated capacity for IDU
and ODU is too low
Setting of main IDU is succeeded
Communication malfunction between mode
exchanger and IDU
Emergency operation DIP switch code of
compressor is wrong
Malfunction of multiple main control units
Charging of refrigerant is invalid
Address DIP switch code of system is
shocking
Identification malfunction of IDU of mode
exchanger
Malfunction of multiple wired controller
Communication malfunction between IDU,
ODU and IDU’s wired controller
Communication malfunction between IDU
and the receiving lamp
Communication malfunction between main
control and DC-DCcontroller
Overflow distribution of IP address
Communication malfunction between main
control and inverter compressor driver
Communication malfunction between mode
exchanger and ODU
Communication malfunction between main
control and inverter fan driver
Malfunction of network for IDU and ODU of
mode exchanger
Malfunction of lack of IDU
Communication malfunction of mode
exchanger
Alarm because project code of IDU is
inconsistent