Wired Controller XK49
12
(1) Long press MODE and SWING button for 5s to enter the interface of viewing
unit parameters. “C00” is displayed in temperature zone and “CHECK” icon is light;
(2) Press “ ” or “ ” button to select parameter code;
(3) Press SWING button to return to last step until exits viewing parameters.
The parameter enquiry list is as following:
Table 3.1 Parameters viewing list
In “C00” status, Timer zone shows the current
indoor unit project number. When one wired
controller is controlling multiple indoor units, then
only the smallest project number will be displayed.
Operation method:
Enter viewing, press MODE button in “C01” status
to enter the interface of viewing indoor unit project
number. Press “ ” or “ ” button to select the
project number of indoor unit.
Display method:
Temperature zone: displays error codes of the
current indoor unit( The temperature zone will
display the error codes in turn with an interval of 3
seconds if there are several malfunctions in one
indoor unit.)
Timer zone: displays present indoor unit project
number /C5 malfunction of project number conflict
Note:
1) If master indoor unit exists in current indoor unit
network, “MASTER” icon will be bright under “C01”
interface. After entering the interface of viewing
project number, “MASTER” icon will be bright only
when the project number of master indoor unit is
selected.
2) System will not exit “C01” viewing automatically.
User has to exit this interface manually.
Operation method:
Enter viewing: press MODE button in “C06” status
to enter the interface of viewing priority operation.
Press “ ” or “ ” button to select indoor unit.
Display method:
Temperature zone: displays current indoor unit
project number;
The data display area:displays current priority
operation setting value of indoor unit.
To Next Page
Loading...
