Gree XK55 - Page 26

Wired Controller XK55
22
Here you can set user parameters. On the left side, it is a list of parameter
names; on the right side, (example) indicates the current setting value
(except those that need confirmation in a pop-up window, for example, the clearing of
cleaning time); press the corresponding button to set the parameter.
 Press
to return to the previous page.
NOTE: Parameter setting is only effective when the master wired controller is on.
Table 4.4 List of user parameters
Setting item
Setting scope
Default
Remarks
Master wired
controller
Yes; No Yes —
Master indoor unit Yes; No No —
High ceiling
installation
On; Off Off —
Operation priority On; Off Off
In case of insufficient power
supply, operation priority can be
set to enable some units to run
while other units to stop.
Receive remote
control signal
On; Off Off —
Link to the fresh air
indoor unit
On; Off Off
After the linkage is enabled, the
fresh air indoor unit will be on or
off as the other indoor units are
turned on or off. It's also OK to
turn on or off the fresh air unit
independently.
NOTE: this function is only
applicable for fresh air indoor
units.