Page 8
Turning the Unit On
Press the POWER BUTTON on the CONTROL
PANEL or REMOTE to turn the unit on. Unit will
initially be set to “PURIFCATION LEVEL 1”
Controlling Fan Speed
Fan speed can be controlled on both the
machine’s CONTROL PANEL as well as with the
REMOTE.
Three speeds are available (Low, Medium, High)
and are adjusted with the FAN UP/DOWN
buttons.
Purication Level
Purication level is controlled on the REMOTE
and adjusts the frequency of Ozone/Activated
Oxygen distribution. Four levels are available
ranging from 1-4. An LED on the control panel
will relate to the current level by varying colors.
(1) Also known as NORMAL MODE is the
standard mode which uses only PCO Technology
and is suitable for areas from 0-250ft
². The LED
on the control panel will be OFF when set at
level 1.
(2) Also known as LOW, is for areas of 250-
500ft². The LED on the control panel will be
GREEN when set to level 2.
(3) Also known as MEDIUM, is for areas of 500-
1000ft². The LED on the control panel will be
YELLOW when set to level 3.
(4) Also known as HIGH, is for areas of 1000-
1500ft². The LED on the control panel will be
RED when set to level 4.
CAUTION: Never adjust the setting to exceed
the square footage of the ventilated space being
treated.
Operations & Maintenance
PCO Cell Replacement
The PCO CELL does wear out and should be
replaced at least once per year of constant use.
Purication Plate
Replacement
The PURIFICATION PLATE does not wear out
as often and would need to be replaced every 2-3
years of constant use, perhaps earlier depending
on how harsh your environment is.
Purification Plate
PCO Cell
Away Mode
Press the AWAY MODE button and verify that the
button is lit on the CONTROL PANEL.
CAUTION: Do not use AWAY MODE in occupied
spaces. Short term exposure to ozone levels above
.05 ppm can cause temporary adverse reactions.
To Next Page
Loading...
Need help?
General
