GreenValley LiBase - Data Import; Data Export; Libase Receiver Recalibration

14
PAGE
05
LiBase Receiver Recalibration
Under normal operation modes, recalibration is required when these two
situations occur:
Connect the LP1 handbook from GreenValley to the computer with the
matching data cable, after the drop-down at the top of the handbook
selects the "transfer file" method. The LP1 storage drive letter will appear on
the computer interface. The measurement data path is GreenValley/ls/Ex-
port. The measurement task path is GreenValley/ls/Project.
he base station has been re-erected or the tripod has been moved artifi-
cially;
1
After setting the mobile station to the fixed solution state, enter (Base
Station recalibration), collect a GNSS point at the control point through
point measurement (i.e., collect coordinates at known control points),
Then select (Known Point) (or input the known coordinates of the
control point) → (Calculate) → (Apply).
After the operation is completed, other control points must be retested.
The measured coordinates are consistent with the known coordinates,
indicating that the base station is successfully calibrated, and the mea-
surement and stakeout work can be continued.
Base station receiver restart.
2
06
Data Transmission
4.6 Data Import
(Project) → (Data Import) → Select the file format and point type, and select
the desired file according to the path (the selected file format must be
consistent with the actual file).
4.7 Data Export
(Project) → (Data Export) → Select the exported data format, filter the
exported point type and acquisition time, enter the file name, select the
save path, and click OK. It can be exported in CSV, txt, and dat formats. To
export detailed data information or other formats, you need to select a
format from "More Formats" for data export.
15
PAGE
04
Functional Usage