EasyManua.ls Logo

Greenwood Unity CV2GIP - View Fan Setup and Status

Greenwood Unity CV2GIP
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 13
Part 2a Installation details
2.1 Installation Checklist General (all Systems) Tick as appropriate
Has the system been installed in accordance with
manufacturer’s requirements?
Have relevant system installation clauses been followed as
detailed in Tables 1, 3, 5 and 7 as applicable?
Type of ductwork installed (e.g. rigid, semi-rigid)
If any deviation from Tables 1, 3, 5 and 7, these
should be detailed here.
Description of installed controls
(e.g. timer, central control, humidistat, PIR, etc)
Location of manual / override controls
Yes No
Yes No
2.2 Installation Engineer’s Details
Name
Company
Address Line 1
Address Line 2
Telephone Number
Post Code
Signature
Competent Person Scheme /
Registration Number (if applicable)
Date of Installation (completion)
Part 2b Inspection of Installation
2.3 Visual Inspections General (all Systems) Tick as appropriate
Total installed equivalent area of background ventilators
in dwelling?
Total floor area of dwelling?
Does the total installed equivalent ventilator area meet the
requirements given in Tables 5.2a, 5.2b, or 5.2c in ADF?
Have all background ventilators been left in the open position?
Have the correct number and location of extract fans/
terminals been installed that satisfy Table 5.2a in ADF?
Is the installation complete with no obvious defects present?
Do all internal doors have sufficient undercut to allow
air transfer between rooms (i.e. 10 mm over and above
final floor finish)?
Has all protection/packaging been removed (including from
background ventilators) such that system is fully functional?
For ducted systems, has the ductwork installation been
installed in such manner that air resistance and leakages
kept to a minimum?
Are the correct number and size of background ventilators
provided that satisfy ADF?
Has the entire system been installed such that there
is sufficient access for routine maintenance and
repair/replacement of components?
Upon initial start up, was any abnormal sound or vibration
experienced, or unusual smells detected?
mm
m
2
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
This section should be completed
before completing part 3.

Other manuals for Greenwood Unity CV2GIP

Related product manuals