8
To Change the Greenwood HumidiSMART
TM
Setting
The Greenwood HumidiSMART
T
M
monitors the humidity of the extracted air at all times. A
rapid rise in humidity from a bath / shower, should be picked up by the sensor and should
cause the fan to automatically switch to Boost mode.
When humidity falls below a calculated threshold close to background levels, the fan
should return to trickle mode.
To identify current fan status, press any button to activate the panel. Upon
identification of control status, either press [ ] to activate or deactivate the Greenwood
HumidiSMART
TM
. Please note the light should come on to indicate that the function is
active.
Factory set to OFF
Option’s ON / OFF
Note: After approximately 10 seconds of
inactivity, the control panel lights should
turn off and save selection settings.
Note: This feature can be activated
at the same time as the Greenwood
TimerSMART
TM.
3.1.4
To Next Page
Loading...
