Greenwood Unity CV2GIP - Change TimerSMART Setting

9
To Change the Greenwood TimerSMART
TM
Setting
The Greenwood TimerSMART
T
M
monitors the length of time the unit has been in boost mode
via the Switch Live. Once the Switch Live is deactivated the Greenwood TimerSMART
TM
over-run period should continue to run the unit for a calculated time if required.
Note: The first 5 minutes should not activate an over-run.
To identify current fan status, press any button to activate the
panel. Upon identification of control status, either press [ ] to
activate or deactivate the Greenwood TimerSMART
TM
. Please
note the light should come on to indicate that the function is
active.
Factory set to OFF
Option’s ON / OFF
Note: After approximately 10 seconds of
inactivity, the control panel lights should turn
off and save selection settings.
Note: This feature can be activated
at the same time as the Greenwood
HumidiSMART
TM.
3.1.5
Time ‘Switch Live’ is Active
0 – 5 minutes
5 – 10 minutes
10 – 15 minutes
15+ minutes
Over-run Boost Period
No over-run
5 minutes
10 minutes
15 minutes