OPERATING
Trimmer Tips.
Before each use
• Make sure the protective guard is tightly installed.Tighten the guard screw.
• Make sure the battery is fully charged and that the charger is disconnected before using or
storing the trimmer.
• Do not store the grass trimmer in sunlight, in an excessively warm place, or near a furnace. The
battery life will be shortened.
• If the battery must be stored in a warm place, charge it frequently.
• Before trimming, inspect the area for string, wire, branches or other material that may become
entangled in the cutting line and thrown. During use.
• Trim only when the grass and weeds are dry.
• Do not trim grass at night. Always make sure you have adequate lighting.
• Hold the grass trimmer by both the switch handle and the auxiliary handle for best control and
balance.
• Stand with the cutting head tipped down at an angle in front, guiding the grass trimmer in a
semicircular motion around you.
• If possible, guide the grass trimmer to the left to cut.The line will cut as soon as it leaves the
guard, and the clippings are thrown away from you.
• To produce a smoothly trimmed area, move the grass trimmer in and out of the area being cut
with consistent speed and height.
• Use only the tip of the cutting line to do the trimming, especially near walls and fences.
Trimming with the side of the cutting line may over load the motor, wear out the line faster, and
break the line more often.
• Do not rest the trimmer spool on the ground while trimming. This will cause spool wear and
battery drain.
• If the grass is higher than 6” (15 cm), trim in small stages.
• When the grass trimmer is turned off and the spool stop srotating, the cutting line will relax
and may recede. Feed extra cutting line before storing the trimmer to prevent losing the line
completely into the spool.
16
To Next Page