Motor buzzes but fails
to run.
Supply voltage below mini-
mum.
Verify that only the pressure
washer is running on this circuit.
System has residual pres-
sure.
Turn unit “OFF”, squeeze trigger
on spray wand to release pres-
sure, then turn unit “ON”
Voltage loss due to
extension cord.
Unplug any extension cords at-
tached and plug the unit
directly into the outlet.
Pressure washer not used for
long periods.
Call the Toll-Free Hotline.
Residual friction among com-
ponents. Unit might hum.
Disconnect water supply and
power ON for 2 to 3 seconds,
repeat couple times or until
the motor starts.
Quick connect assembly is
attached in reverse.
Verify that Inlet adapter (G2) is
attached to machine’s water inlet
and that the quick connect coupler
(G1) is attached to garden hose.
Remove kink in garden hose.
NOTE: AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto
Start/Stop feature. To operate: Press power switch On (I). Pump will pressurize
and shut down immediately.Once the trigger of the gun is depressed the unit
will turn on. Unit will shut off and be in standby mode when trigger is released.
26
To Next Page
Loading...
