GreenWorks 51152 - Page 17

17
OPERATION
STARTING AND STOPPING THE PRESSURE WASHER
(See Figure 7.)
CAU TIO N :
Do not run the pump without the water supply connected and turned on.
• Connect the garden hose.
• Turn the garden hose on then squeeze the trigger to relieve air pressure. Once a steady stream
of water appears,release the trigger.
• After ensuring the On/Off switch is in the OFF ( O ) position,connect the pressure washer to the
power supply.
• Press the reset button on the pressure washer’s plug to make sure the unit is ready for
operation.
Fig. 7
• Press ON ( I ) on the switch to start the motor.
• To stop the motor, release the trigger and press OFF( O ) on the switch.
NOTE: The pressure washer may be on and the system may have pressure even when the pump and/or motor
cannot be heard running. Always use caution around the pressure washer.
W ARN I N G
Hold the trigger handle securely with both hands. Expect the trigger handle to move when the
trigger is pulled due to reaction forces. Failure to do so could cause loss of control and injury to
yourself and others.
NOTE: AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto Start/Stop feature.
To operate: Press power switch On (I). Pump will pressurize and shut down immediately.
Once the trigger of the gun is depressed the unit will turn on. Unit will shut off and be in standby mode
when trigger is released.
Soap is applied under low pressure high volume for optimum performance.
Soap cannot be applied under high pressure with this machine.
On/off
switch