When the log is held on two ends (37):
1. Cut the first time 1/3 of the diameter from the top
(36).
2. Cut the second time lower 2/3 from the bottom (35)
to complete the bucking.
When the log is on a slope:
1. Stand on the uphill side.
2. Control the chainsaw completely.
3. Hold the chainsaw handles tightly.
4. Release the cutting pressure near the end of the
cut.
When bucking is complete:
1. Wait for the chain to stop.
2. Ensure the chainsaw is turned off.
3. Check for hazards before you move to another tree.
10 MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
10.1 REPLACE THE GUIDE BAR AND
THE CHAIN
1. Loosen the chain cover by turning the chain cover
knob counterclockwise.
2. Remove the chain cover.
3. Put the chain drive links (21) into the bar groove
(20).
4. Put the chain cutters (22) in the direction of the
chain operation.
5. Put the chain in position and make sure that the
loop is behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (17).
11
English
EN
To Next Page
Loading...
Need help?
General
