Problem Possible cause Solution
The machine does
not start. The chain brake is
engaged.
Pull the chain
brake in the direc-
tion of the user to
disengage it.
The machine and
battery are not
connected correct-
ly.
Make sure that the
battery release
button clicks when
you install the bat-
tery pack.
The battery level
is low.
Charge the battery
pack.
The lock out but-
ton and the trigger
are not pushed at
the same time.
1. Push the lock-
out button and
hold it.
2. Push the trig-
ger to start the
machine.
The battery is too
hot or too cold.
Refer to battery
and charger man-
ual.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3 sec-
onds.
The machine is in
the protection
mode to protect
the PCB.
Release the trigger
and start the ma-
chine again. Do
not force the ma-
chine to cut.
The battery is not
charged.
Charge the battery.
Refer to the bat-
tery and charger
manual for correct
charging proce-
dures.
The chain is not
lubricated.
Lubricate the
chain to decrease
the friction. Do
not let the guide
bar and the chain
operate without
sufficient lubri-
cant.
Incorrect battery
storage tempera-
ture
Cool the battery
pack until it de-
creases to the am-
bient temperature.
8 TECHNICAL DATA
Voltage 40 V DC
No load speed 12 m/s
Guide bar length 254 mm
Chain stop < 0.15 s
Chain oil capacity 120 ml
Weight (without battery
pack)
2.4 kg
Measured sound pressure
level
L
pA
= 84 dB(A), K
pA
= 3
dB(A)
Guaranteed sound power
level
L
wA.d
= 102 dB(A)
Vibration 4.4 m/s
2
, K = 1.5 m/s
2
Chain 25AP058X
Guide bar 100SDAA041
Battery model G40B2/G40B25/G40B4/
G40B5/G40B6 and other
BAF series
9 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: GLOBGRO AB
Globe Group Europe
Address: Riggaregatan 53, 211 13 Malmö, Sweden
Name and address of the person authorised to compile the
technical file:
Name: Peter Söderström
Address: Riggaregatan 53, 211 13 Malmö, Sweden
Herewith we declare that the product
Category:
Chainsaw
Model: 2003807(CSF405)
Serial number: See product rating label
Year of Construction: See product rating label
• is in conformity with the relevant provisions of the
Machinery Directive 2006/42/EC.
• is in conformity with the provisions of the following
other EC-Directives:
• 2014/30/EU
• 2000/14/EC & 2005/88/EC
• 2011/65/EU & (EU)2015/863
Furthermore, we declare that the following (parts/clauses of)
European harmonised standards have been used:
• EN 60745-1, EN 60745-2-13, EN 55014-1, EN 55014-2,
EN ISO 3744, ISO 11094, IEC 62321-3-1, IEC 62321-4,
IEC 62321-5, IEC 62321-6, IEC 62321-7-1, IEC
62321-7-2, IEC 62321-8, EN ISO 11681-2
10
English
EN
To Next Page
Loading...
