GreenWorks MO80L06 - Troubleshooting; Technical Data

EN
English
14
5. Stand the machine on end and make sure that
the brackets touch the floor.
10 TROUBLESHOOTING
Problem
Possible cause
Solution
The handle is
not in position.
The bolts are
not engaged
correctly.
Adjust the
height of the
handle and
make sure that
the bolts and
nuts are aligned
correctly.
The machine
does not start.
The battery ca-
pacity is low.
Charge the bat-
tery pack.
The start han-
dle is defective.
Replace the
start handle.
The battery key
is not put in.
Put in the bat-
tery key.
The machine
cuts grass un-
evenly.
The lawn is
rough.
Examine the
mowing area.
The blade
height is not set
correctly.
Move the
wheels to a
higher position.
The machine
does not mulch
correctly.
Wet grass clip-
pings attach to
the deck.
Wait until the
grass dries be-
fore mowing.
The mulch plug
is missing.
Install the mulch
plug.
The machine is
hard to push.
The grass is too
tall, or the blade
height is too
low.
Increase the
blade height.
The grass
catcher and the
blade drags in
thick grass.
Empty the grass
clippings from
the grass catch-
er.
Problem
Possible cause
Solution
There is a high
vibration in the
machine.
The blade is un-
balanced and
worn.
Replace the
blade.
The motor shaft
is bent.
1. Stop the
motor.
2. Remove
the safety
key and
battery
pack.
3. Disconnect
the power
source.
4. Inspect for
damage.
5. Repair the
machine
before you
start it
again.
The machine
The blade
Increase the
stops during
height is too
blade height.
mowing.
low.
The battery
Charge the bat-
pack is out of
tery pack.
power.
The grass clip-
Remove the
pings attach to
battery pack
the deck or the
and check the
blade.
deck.
Operation tem-
Cool the ma-
perature of the
chine.
machine is too
high.
* If you cannot find the solution to these problems, go
to the service center.
11 TECHNICAL DATA
Voltage
80 V
Motor
Brushless
No load speed
2800 RPM / 3200 RPM (Tur-
bo)
Self-propelled
speed
1.9-4.9 fps (0.6-1.5 m/s)
Deck size
21"
Height adjustments
1-3/8 - 4” (3.5 - 10.2 cm)