SOFTWARE & TUNING 38
STEP 02 - ROLL STIFFNESS
STEP 03 - PAN STIFFNESS
Slowly increase this setting until you feel an oscillation in the roll axis, then
reduce the setting until the oscillation subsides. Pick the T3 up and make sure
there is no vibration when you move the gimbal around.
Slowly increase this setting until you feel an oscillation in the pan axis, then
reduce the setting until the oscillation subsides. Tilt the T3 about 20 degrees
from the verticality and make sure that no vibrations are presented.
STEP 01 - TILT STIFFNESS
Slowly increase this setting until you feel an oscillation in the tilt axis, then reduce
the setting until the oscillation subsides. Make sure there is no vibration when
tilting the camera up and down and when moving the gimbal in any orientation.
To Next Page
Loading...