REMOTE CONTROL
T3 supports SBUS , SPEKTRUM and PPM receivers. There
are some parameters to be aware of before assigning
channels to the receiver.
SMOOTH: increasing this number will smooth out the
movement of the corresponding axis but will also cause
a delay.
SPEED MODE: when speed mode is selected, the
speed of the corresponding axis will depend on how
far the stick position is from the neutral position. It is
recommended that TILT and PAN channels should be set
to speed mode.
ANGLE MODE: when angle mode is selected, the
corresponding axis will move to the angle set by current
stick/knob position. It’s recommended ROLL channel
should be set to angle mode.
To Next Page
Loading...