Grill Chef 12120 - Page 9

9
Timer Instructions
MAIN FEATURE
1. LCD count-down timer.
2. 4 digits display showing minute ( “M” mark ) and
second ( “s” mark ).
3. Timing range:1~99´59”
4. Buzzing output when timer counts down at last
second.
5. Timer memory recall function.
6. [MIN], [SEC] individual buttons for minute and second
setting.
7. Clockwise function.
TIMING SETTING
1. Press MIN button to advance minute digits (deep
sound can be heard).
Press and hold MIN button for speed setting.
2. Press SEC button to advance second digits (deep
sound can be heard).
Press and hold SEC button for speed setting.
3. Press MIN and SEC button at the same time to reset
timer to zero.
TIMER START/STOP
1. After time setting is ready, press Start/Stop button
once and timer will start to count down. “M” and “S”
marks will flash when timer is counting.
2. Press Start/Stop button once and timer will stop. “M”
and “S” marks will stop flashing.
3. Press Start/Stop button once and timer will resume
counting again.
4. After buzzing stop, press Start/Stop button to return
to last setting time.
TIMER BUZZER ALARM
1. When timer counts down to 00
M
00
S
, timer buzzing
will sound for 30 seconds.
2. Buzzing can be stopped by pressing any button.
TIMER MEMORY RECALL
1. After buzzing stops, press Start/Stop button once
to recall pre-set time and timer will count down for
another lap.
2. Press Start/Stop button once, timer will count down
for another lap.
CLOCKWISE FUNCTION
Press [MIN] and [SEC] button at the same time, when
display shows 00
M
00
S
Press [START/STOP] button once, going to clockwise.
BATTTERY REPLACEMENT
Follow the arrow direction to open the battery cover at
back side of timer.
Remove old battery, insert a new “AAA” battery as
indicated by the polarity symbols (+ & -) marked
and closed battery cover.
PRODUCT SHOWS
CLIP ATTACHMENT
The timer can clip on thin board or shirt pocket,
using the plastic clip at rear of timer. The timer can
attach to iron or a steel surface, using the magnet
at the rear of timer. The timer can stand on table
surface, by flipping out the metal stand bar at the
rear of timer.