24
GRILLCHEF
Trouble shooting
If there is a fault despite due care, this chapter may help you to resolve the malfunction.
Malfunction Cause Remedy
There is a smell of gas Leak in the gas system 1. Close the cylinder valve immediate-
ly (turn operating lever (G2) to a 3
o'clock position).
2. Prevent any ames or sparks (do not
switch on electric devices)
3. Tighten all connections of the gas
system.
4. Check all components of the gas
system for external damage; replace
defective parts with original spare
parts.
5. Use a leak detection agent to check
the gas system for leaks.
Burner does not light Gas cylinder is empty Replace the gas cylinder
Cylinder valve is closed Turn the operating lever (G2) to a 6
o'clock position
Nozzles of the adjusting element
(underneath the front panel) are not
inserted into the burner pipes
Conduct a visual check, if necessary align
the nozzles and connection hoses
The igniter cable is not connected to
the Piezo igniter (A)
Conduct a visual test, connect if neces-
sary
Distance between spark plug and
gas outlets on the burner (10) is in-
correct
Visual inspection; correct if necessary
Jet on the adjusting element (be-
neath the front panel) is blocked
Remove the front panel and clean the jet
of the adjusting element with a pin
Other gas system is blocked The gas system should be cleaned by a
specialist
Temperature on grill too low Pre-heating time is too short Close the lid (1) and set the ame regula-
tor to max. setting.
Gas outlets on the burner (10) are
blocked
Remove blockage from burner
Fatty foods Remove any large areas of fat prior to bar-
becuing or place the meat on a grill plate
or reduce the barbecue temperature
To Next Page
Loading...
