26
GRILLCHEF
Troubleshooting
If there is a fault despite due care, this chapter may help you to resolve the malfunction.
Malfunction Cause Remedy
There is a smell of gas Leak in the gas system 1. Close the cylinder valve immediately
(turn G1 clockwise)
2. Prevent any ame or spark
formation (do not switch on any
electrical appliances)
3. Tighten all connections of the gas
system
4. Check all components of the gas
system for external damage; replace
defective parts with original spare
parts
5. Check for leaks using a leak detector
Burner does not light Gas cylinder is empty Replace the gas cylinder
Cylinder valve is closed Turn the cylinder valve (G1) anti-
clockwise
Nozzles of the adjusting element
(underneath the front panel) are not
inserted into the burner hoses
Conduct a visual check, if necessary align
the nozzles and connection hoses
Distance between the spark plug and
gas outlets on the burner is incorrect
Visual inspection; correct if necessary
Nozzle on adjusting element
(underneath front panel) is blocked.
Remove the front panel and clean the
nozzle of the adjusting element using a
pin
Other gas system blocked The gas system should be cleaned by a
specialist
Temperature on grill too low Pre-heating time too short Close lid and set ame regulator to max.
setting
Gas outlets on the burner are blocked Remove blockages from burner
Popping or bubbling noise Flashback caused by blockages in the
burner.
1. Close the cylinder valve immediately
(turn G1 clockwise)
2. Wait 3 minutes and then switch the
barbecue back on
3. If the malfunction reoccurs,
disassemble and clean the burner
To Next Page
Loading...
