Grizzly BRM 41-125 BSA User Manual (English)

Questions and Answers:

P
palmercharlesAug 2, 2025
How to start a Grizzly Lawn Mower if the engine does not start?
- Y
  yarmstrongAug 2, 2025
  If the Grizzly Lawn Mower engine doesn't start, it might be due to several reasons. First, ensure there's enough petrol in the tank; if it's low, fill it up. Another reason may be an incorrectly attached spark plug connector or a sooted spark plug. Attach the spark plug connector correctly. Clean, adjust, or replace the spark plug. Finally, the starting sequence might be incorrect, so make sure to follow the instructions for starting the engine.
P
Pamela GregoryAug 6, 2025
Why is my Grizzly Lawn Mower engine overheating?
- C
  christopherhodgesAug 6, 2025
  If your Grizzly Lawn Mower engine overheats, several factors could be the cause. Check if the ventilation holes are blocked and clean them if necessary. An incorrect spark plug can also cause overheating, so replace it. Finally, ensure there is enough engine oil; if it's too low, fill it to the correct level.
P
Paula MarshAug 10, 2025
What to do if my Grizzly Lawn Mower output is unsatisfactory?
- N
  Nicole TaylorAug 10, 2025
  If the output of your Grizzly Lawn Mower is unsatisfactory, or the engine is labouring, consider these potential causes: the grass might be too short or too long, in which case you should change the cutting height. Also, the blade might be blunt, and you should have it sharpened or replaced by a specialist workshop. Finally, the blade might be blocked with grass, the grass collection box might be full, or the ejection channel might be blocked; in this case, remove the grass.
D
davidperryAug 14, 2025
Why Grizzly Lawn Mower starts but does not run at full power?
- D
  Daniel HesterAug 14, 2025
  If your Grizzly Lawn Mower engine starts but doesn't run at full power, it could be due to a dirty air filter, so replace the air filter. Another possible reason is that the gas lever is not in the correct position, so check the gas lever position.
L
Laura LambertAug 19, 2025
What to do if Grizzly Lawn Mower engine splutters and stops?
- S
  sleeAug 19, 2025
  If your Grizzly Lawn Mower engine sputters and stops, it could be due to a sooted spark plug. Clean, adjust, or replace the spark plugs.
J
Jennifer WhiteAug 23, 2025
What to do if the blade of my Grizzly Lawn Mower does not turn?
- C
  cody92Aug 23, 2025
  If the blade of your Grizzly Lawn Mower does not turn, it might be blocked with grass. Remove the grass.
M
Matthew SimsAug 27, 2025
What causes the drive on my Grizzly Lawn Mower not to switch on?
- B
  Benjamin StevensonAug 27, 2025
  If the drive on your Grizzly Lawn Mower doesn't switch on, it could be because the Bowden cables are misadjusted. Adjust the Bowden cables.

Grizzly BRM 41-125 BSA Specifications

General

Cutting Width	41 cm
Engine Type	4-stroke
Cutting Height Adjustment	Central
Cutting Height Range	25-75 mm
Grass Collector Volume	50 L
Weight	26 kg
Engine	Briggs & Stratton