Why are the blades on my Grizzly Lawn Mower worn/damaged frequently?
If your Grizzly Lawn Mower blades are worn or damaged frequently, it might be because the cutting height is too low, causing the blades to touch the ground. To resolve this, raise the cutting height of your mower.
How to fix excessive vibration in my Grizzly SGM Lawn Mower?
Excessive vibration in your Grizzly Lawn Mower can stem from several issues. It could be due to breakage or excessive wear of the blades, in which case you should replace them. Other potential causes include worn spindle shaft bearings (replace the bearings), damaged blades (replace the blades), damaged belts (replace the drive belt), or damaged pulleys/bearings (replace the pulleys/bearings). Also, check for any object wrapped around the blade or belt area, and remove any debris or objects found.
What to do if the rear discharge area of my Grizzly Lawn Mower is plugged?
If your Grizzly Lawn Mower's rear discharge area is plugged, it may be due to wet grass. Wait until the grass dries before mowing. If the grass is too high, raise the cutting height of the mower and cut the grass in two passes, also shift the transmission to a lower gear. If the tractor rpm is too slow, mow at full throttle (540 PTO rpm), and check the PTO speed and tractor engine.
Why is the belt slipping on my Grizzly SGM?
If your Grizzly Lawn Mower belts are slipping, it could be due to debris clogging the mower deck or belts area. Unplug and clean the mower deck, and remove the belt guard shields to clean the belts area. Also, check for lack of tension and tighten the belts if needed. If the belt is worn or damaged, replace it.
Why does my Grizzly SGM Lawn Mower leave patches/streaks of uncut grass?
If your Grizzly Lawn Mower is leaving patches or streaks of uncut grass, it could be because the grass is too wet to mow, allow the grass to dry. It may also happen because blades are unable to cut part of grass pressed down by wheels, keep engine speed at full PTO but slow ground speed shifting to lower gear and lower cutting height. Also, check for dull blades and sharpen or replace them if necessary. If the tip blades are worn, preventing overlap, replace the blades. Check blade hardware, if the blade is loose.
Why are the belts on my Grizzly SGM overheating?
If your Grizzly Lawn Mower belts are overheating, ensure that the belt tension is correct. Also, check the alignment of the transmission axis and rotor axis.
Why is the belt squealing on my Grizzly Lawn Mower?
If your Grizzly Lawn Mower's belt is squealing, it's likely due to the belts slipping. Try tightening the belts to resolve this issue.
General| Brand | Grizzly |
|---|---|
| Model | SGM Series |
| Category | Lawn Mower |
| Language | English |
To Next Page