To Next Page

To Previous Page

GROOMING MOWERS - SGM Series - Models SGM 48-60-72-84

To change from fixed to floating position, of 3 – point hitching bracket , remove hex bolt (A), two

bush (B) & nut (c) from bracket

5.4. STOPPING AND DISCONNECTION

To stop the mower at the end of a working session:

 Bring the tractor on a dry and level surface;

 Stop the tractor and place the transmission in park or neutral;

 Reduce the engine speed, then disengage the PTO;

 Wait for stopping of all rotating parts;

 Set the parking brake;

 Shut down the engine and remove the key before exiting the tractor;

 Do the cleaning and maintenance required to make the machine ready for later use (see section

Maintenance).

WARNING

Never leave the tractor unattended with the implement in the lifted position.

To disconnect the mower from the tractor (e.g. to make a change of implement):

 Bring the tractor on a dry and level surface;

 Stop the tractor and place the transmission in park or neutral;

 Reduce the engine speed, then disengage PTO;

 Wait for stopping of all rotating parts;

 Set the parking brake;

 Shut down the engine and remove the key before exiting the tractor;

 Disconnect the driveline from the tractor PTO and rest it on and store in appropriate

place;

 Disconnect the top link and the rear lifting arms of the tractor from the mower hitches;

 Check the mower stability. If needed, place safety blocks;

 Get on the tractor, start the engine and move away from the mower slowly;

Grizzly SGM Series User Manual

Questions and Answers: