GROOMING MOWERS - SGM Series - Models SGM 48-60-72-84
26
Make sure that the mower remains stored in a protected area, to prevent that unauthorized
per-sonnel can approach it.
Before a long term storage (e.g. at seasonal end), do cleaning and maintenance operations as
specified in sections Maintenance and Storage.
5.5. TRANSPORT
To set the mower for transportation, perform the following steps:
Idle tractor engine, disengage tractor PTO, and wait for stopping of all rotating parts;
Adjust the tractor top link so that when lifted, the rear of the machine is higher than the front.
To do this, shorten the tractor top link until the top hitch plate is locked forward and no longer
able to pivot. This will keep the mower locked and minimize the shaking and bouncing during
transport, avoiding damages to the hitch a frame.
Lift the mower until the transport position, making sure the driveline transmission tubes does
not hit either the tractor or the gearbox mower. A minimum gap of 2 cm should be leaved
between the tubes and tractor and mower (see also section Driveline installation). The mower
should not be lifted over 14”-16” from the ground.
Lock the tractor lifting hydraulics, turn off the engine, set the parking brake, remove ignition
key and get off the tractor.
Make sure PTO is disengaged and blades have stopped turning before raising mower to transport
position.
Never leave the tractor unattended with the implement in the lifted position.
During transportation:
Always use caution and select a safe ground speed that is appropriate for the terrain. Reduce
speed when under adverse surface conditions, turning, or on inclines. Take care that the imple-
ment does not strike obstacles such as trees, fences or buildings.
Do not operate PTO. Always transport the implement with disengaged PTO.
A minimum 20% of tractor and equipment weight must be applied to the front wheels when at-
tachments are in transport position. Without this weight, front tractor wheels could raise up re-
sulting in loss of steering. The weight may be attained with front wheel weights, ballast in tires
or front tractor weights.
Do not transport on steep slopes.
Do not transport equipment while under the influence of alcohol or drugs.
Never allow riders on power unit or attachment.
When driving on public roads, install a SMV (Slow Moving Vehicle) sign. Always comply strictly
with all federal, state and local laws and traffic regulations.
When driving on public roads, reduce your speed, be aware of traffic around you and proceed in
such a way that faster moving vehicles may pass you safely.
To Next Page
Loading...
Need help?
General
