Grizzly SGM Series User Manual

GROOMING MOWERS - SGM Series - Models SGM 48-60-72-84
34
7. STORAGE
Before leaving the mower unused for a long time, perform following tasks to preserve the appear-
ance and functionality of the implement, and to make easier the restart at later use:
 Park the mower on a flat surface, in a place dry and protected from exposition to the elements,
possibly with storage temperature between 0 and 50 °C (see section Stopping and disconnec-
tion);
 Thoroughly clean the machine, removing from the blades clamps of dirt and all residues due
to mowing, in order to avoid damage from grass and stagnant water;
 Inspect carefully the machine, checking for worn and/or damaged parts. Perform immediately all
repairs and/or replacements needed, in order to make the machine ready for restarting;
 In case of abrasion of painted surfaces, provide restoring the surface protection through touch-
up paint to prevent rust;
 Make sure the safety decals are in their original positions, intact and legible. When required, re-
place the decals immediately;
 Lubricate properly all grease points, and restore the oil levels as indicated in the
Maintenance section. Use protective oil to coat the exposed mechanical components and to
protect them against rust.
8. SCRAPPING
In case of scrapping, the machine must be disposed in appropriate and authorized sites, according
to local legislation of the Country where the machine is used.
Before scrapping, separate plastic parts from rubber parts, aluminum, steel, etc.
Recover and dispose any exhausted oils to authorized centers for oil collecting.
9. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Excessive vibration
Breakage or excessive wear of
blades
Replace the worn or cracked
blades
Spindle shaft bearings worn
Replace bearings
Uneven cutting
Blades assembled incorrectly
on spindle shafts
Check spindle assembly and re-
store correct position of the
parts (blade, spacer and washer)
Height of mower not leveled
Verify that same amount of
spacers are under the four cast-
er arms. Level mower adjusting
spacers
Belt tension not enough
Adjust proper belt tension
Ground speed too fast
Shift to a lower gear
Blades need sharpen-
ing/balancing
Sharpen/balance blades or re-
place
Caster wheels uneven
Adjust wheel position
Loose blade
Check blade hardware
Imperfect cut
Ground speed too low
Increase ground speed
Tractor rpm too slow
Increase tractor rpm, check

Grizzly SGM Series Specifications

General

Brand	Grizzly
Model	SGM Series
Category	Lawn Mower
Language	English