GROOMING MOWERS - SGM Series - Models SGM 48-60-72-84
35
Raise cutting height by adjusting
wheels
Change mowing pattern. Reduce
speed turns
Blades turning but not cut-
ting
Direction of blades is wrong
Check the blades have cutting
edges facing direction of rotation
Object wrapped around blade
Remove belt guard shields, clean
debris from belt area
Object wrapped around belt
area
Unplug and clean mower deck
Debris clogging belts area
Remove belt guard shields and
clean belts area
Rear discharge area
plugged
Raise cutting height of mower
and cut grass in two pass. Shift
transmission to a lower gear.
Mow at full throttle (540 PTO
rpm), check PTO speed and trac-
tor engine
Incorrect tension of belts
Transmission axis and rotor
axis out of alignment
Blades worn/damaged fre-
quently
Cutting height too low, blades
touching ground
Patches/streaks of uncut
grass
Blades unable to cut part of
grass pressed down by wheels
Keep engine speed at full PTO
but slow ground speed shifting
to lower gear. Lower cutting
height
Tip blades worn, preventing
overlap
Tractor loaded down by
mower
Keep engine speed at full PTO.
Shifting to lower gear