To Next Page

To Previous Page

Trouble Shooting

Problem Possible Cause Fault Fixing

Equipment does not

start

Power is off

Check the socket, cable, wire and

plug and have any repairs carried

out by an electrician

Defective on/off switch

Repair by customer servicesWorn carbon brushes

Defective motor

Grass too long

Set a greater cut height. Lift the

front wheels slightly by pressing

down on the handle bar.

Motor stops Blockage by foreign object Remove the foreign object

Result unsatisfactory

or motor labours

Cut height too low Set a higher cut height

Blade blunt

Have the blade sharpened or re-

place it

Blade area blocked Clean the equipment

Blade assembled incor-

rectly

Install the blade correctly

Blade fails to turn

Blade blocked by grass Remove the grass

Blade screw loose Tighten the blade screw

Strange noises, rat-

tling or vibrations

Blade screw loose Tighten the blade screw

Blade damaged Replace the blade

Spare parts

When ordering spare parts, please use the indicated Service-Center address or fax

number. Please indicate the part number with your order.

Spare blade ....................................................................................................91095738

Grass catcher ..................................................................................................91095751

Grizzly ERM 1844 G Translation Of The Original Instructions For Use

Other manuals for Grizzly ERM 1844 G