To Next PageTo Next PageWhy Grizzly G0555 Saw blade is contacting table insert?
If the blade is contacting the table insert, it could be due to excessive side pressure when cutting, so reduce the side pressure. The table might also be improperly adjusted, so adjust the table. Finally, the opening in the insert could be too narrow, so file the opening in the table insert larger.
How to fix a ticking sound on a Grizzly G0555 Saw?
To address the ticking sound when the saw is running, it might be caused by the weld contacting the thrust bearing. Use the G2516 Stone to smooth and round the back of the blade.
What to do if my Grizzly Saw machine does not start?
If your Grizzly Saw doesn't start, there are several potential causes: * The power supply might be faulty or switched OFF. Ensure the hotlines have the correct voltage and the main power supply is ON. * The plug or receptacle could be faulty or wired incorrectly. Test for good contacts and correct the wiring if needed. * There might be an open or high resistance in the wiring. Check for broken wires or disconnected/corroded connections, and repair or replace them. * The motor connection could be wired incorrectly. * The start capacitor might be faulty (110V only). Test or replace it. * The motor ON/OFF switch might be faulty. Replace it. * The centrifugal switch could be at fault. Adjust or replace it.
General| Cutting Capacity Width | 13-1/2 in. |
|---|---|
| Cutting Capacity Height | 6 in. |
| Table Size | 14 in. x 14 in. |
| Table Tilt | 45° right, 10° left |
| Dust Port Size | 4 in. |
| Motor | 1 HP, 110V/220V, single-phase, TEFC |
