Page 36
To cut rabbets with the standard blade:
1.
2.
3.
4.
5.
Figure 70,
Cutting Rabbets with a Standard
Blade
Figure 70.
Figure 71.
6.
7.
Figure 71
DO NOT place a tall board on edge to per-
form a rabbet cut with a standard blade.
Workpieces that are too tall to properly sup-
port with the fence can easily shift during
operation and cause kickback. Instead, place
the stock flat on the saw and perform the
rabbet cut with a dado blade, as instructed
on Page 48.
To Next Page
Loading...
Need help?
General
