What to do if my Grizzly Saw motor will not start and fuses or circuit breakers blow?
If your Grizzly Saw motor will not start and the fuses or circuit breakers blow, inspect the cord or plug for damaged insulation and shorted wires. Also, inspect all connections on the motor for loose or shorted terminals or worn insulation. If these are not the cause, install correct fuses or circuit breakers.
General| Model | G1011Z |
|---|---|
| Blade Diameter | 10" |
| Table Size | 27 in. deep |
| Maximum Cutting Height | 3-1/8 in. at 90 degrees |
| Arbor Size | 5/8" |
| Max Cut at 90° | 3-1/8" |
| Motor | 3 HP, 220V, single-phase |
Provides essential safety rules for operating power tools, including guards, work area, and user practices.
Offers specific safety instructions for the bandsaw, covering blade handling, material securing, and operational caution.
Identifies and describes the main controls and components of the bandsaw for reference during adjustments.
Explains how to adjust the spring tension to control the downward pressure of the saw bow during cutting.
Details procedures for properly tensioning the blade and aligning its tracking on the wheels for optimal performance.
Describes adjusting support and guide bearings for optimal blade support and cutting accuracy.
To Next Page
