To Next PageTo Next PageHow to fix a Grizzly G1012 blade that doesn't run evenly on wheels?
If the blade on your Grizzly Saw does not run evenly on the wheels or runs off, it could be due to a couple of reasons. The tracking may not be adjusted properly, so adjust the tracking. Also, the wheels might not be coplanar, so adjust the wheel alignment.
What causes a ticking sound when my Grizzly G1012 Saw is running?
If you hear a ticking sound when your Grizzly Saw is running, it might be because the weld is contacting the thrust bearing. Use the G2516 Stone to smooth and round the back of the blade.
Essential safety rules for operating power tools.
Safety guidelines specific to bandsaw operation.
Details on electrical requirements, voltage, and fusing for the bandsaw.
Proper grounding procedures and guidelines for using extension cords.
Introduction to the bandsaw and company contact details.
Information on manual revisions and company policies.
A sequential guide to assembling the bandsaw.
Detailed instructions for assembling the machine's stand.
Identifies and explains the function of various controls on the bandsaw.
Initial machine test and general capabilities of the bandsaw.
Procedures for maintaining V-belts and the saw table.
Technical data, dimensions, and specifications of the bandsaw.
Information on warranty, returns, and customer support.
General
