Drill Press is wired to run on 110V.
Drill Press has a built in light with a ON/OFF switch.
Never hold a workpiece by hand while drilling.
Clamp it down or hold it in a vice.
Never drill sheet metal without it being clamped securely.
Different bits and different materials drill best at certain speeds.
There is a Bit/Material/Speed chart on Page 5 of this guide.
Familiarize yourself with how to change speeds on the Drill Press.
Page 6 of this guide shows how to change speeds.
Full speed chart is under pulley cover on Drill press
Please read the next 8 pages of this guide to gain an understanding of
the operation of the Drill Press itself.
The full manual is available online and a paper copy is here in the shop.
This SOP compiled by @pberglund
To Next Page
Need help?
General
