Saber Hand Wind Audio Player - User Guide
2.2 Indicator lights
The Saber has two lights, one green and one red. The lights indicate the state of the player and
battery.
Indicator Meaning Action
Green light flashing quickly The player is getting starting up Wait until player starts playing
Green light on steady The player is playing normally Press buttons on keypad to pause,
skip, adjust volume or stop
Green light flashing slowly The player is paused Press Power/Pause button briefly to
resume playing
Red light on steady The player is charging Continue to charge until the red
light goes out
Red light flashing The battery is getting low Recharge the player by turning the
handle or plug in an external power
device
2.3 The Internal Battery
Fully charged, the internal battery should allow the Saber to player for 10 hours or more, although
this maximum playing time will decrease
When the built-in battery is nearly flat, the red light will start flashing.
To charge the battery
• Turn the crank handle in a clockwise direction.
• Optionally connect a 7.2V 500mA AC adapter, solar panel or battery pack. (The DC socket is
2.1mm, centre pin positive.)
When the unit is charging, the red light will be on. The unit is fully charged when the red light turns
off. Remove the power supply when fully charged.
2.4 Caring for the Internal Battery
All batteries have a limited shelf life. Follow these instructions to maximize the Saber's battery life,
and minimize the possibility of other problems.
2.4.1 Before First Use: Fully charge the batteries
Batteries lose charge during shipping. Where possible, use the AC/DC Adapter or other external
power source to fully charge the batteries before using the Saber for the first time.
Page 5 of 15
To Next Page
Loading...
