OM-TDB/7
11
Lift the rear edge of the cover first.
WARNING
WHEN TILTING KETTLE FOR PRODUCT
TRANSFER:
1) WEAR PROTECTIVE OVEN MITT AND
PROTECTIVE APRON.
2)
USE DEEP CONTAINER TO CONTAIN
AND MINIMIZE PRODUCT SPLASHING.
3)
PLACE CONTAINER ON STABLE, FLAT
SURFACE, AS CLOSE TO KETTLE AS
POSSIBLE.
4)
STAND TO LEFT OR RIGHT OF KETTLE
(DEPENDING ON HANDLE PLACEMENT)
WHILE POURING — NOT DIRECTLY IN
POUR PATH OF HOT CONTENTS.
5) POUR SLOWLY, MAINTAIN CONTROL OF
KETTLE BODY HANDLE AT ALL TIMES,
AND RETURN KETTLE BODY TO
UPRIGHT POSITION AFTER CONTAINER
IS FILLED OR TRANSFER IS COMPLETE.
6)
DO NOT OVERFILL CONTAINER. AVOID
DIRECT SKIN CONTACT WITH HOT
CONTAINER AND ITS CONTENTS.
CAUTION
KEEP FLOORS IN FRONT OF THE KETTLE
WORK AREA CLEAN AND DRY. IF SPILLS
OCCUR, CLEAN AT ONCE TO AVOID
SLIPS OR FALLS.
Common Accessories
1.
Lift Off Cover
As with stock pot cooking, an optional lift off
cover can speed up the heating of water and
food products. A cover helps retain heat in
the cooking vessel and reduces the amount
of heat and humidity released into the
kitchen. Use of a cover can reduce some
product cook times and help maintain the
temperature, color and texture of products
being held or simmered for extended periods.
Make sure the plastic ball handle is secure on
the lift off cover before using. ALWAYS use
the plastic handle to place or remove cover
from the kettle. Wear protective oven mitts
and a protective apron.
When putting the cover on the kettle, position
it on top of kettle rim, with its flat edge facing
the pouring lip.
WARNING
AVOID ALL DIRECT CONTACT WITH HOT
SURFACES. DIRECT SKIN CONTACT
COULD RESULT IN SEVERE BURNS.
AVOID ALL DIRECT CONTACT WITH HOT
FOOD OR WATER IN THE KETTLE.
DIRECT CONTACT COULD RESULT IN
SEVERE BURNS.
When removing cover:
a) Firmly grasp plastic handle
b) Lift rear
edge (farthest from operator) 1-2”
(3-5 cm) to allow any steam and water vapor
to escape the cooking vessel. Wait 2-3
seconds.
c) Tilt cover to 45-60° angle and allow any hot
condensate or product to roll off cover back
into kettle.
d) Remove cover, ensuring that any remaining
hot condensate or product does not drip on
operator, floor or work surfaces.
e) Place cover on safe, flat, sanitary, out-of-
the-way surface, or return to kettle rim.
CAUTION
DO NOT TILT KETTLE BODY WITH COVER
IN PLACE. COVER MAY SLIDE OFF,
CAUSING INJURY TO OPERATOR.
To Next Page
Loading...
Need help?
General
