- 19 -
Fig.4.6.1 Power information interface
2. Check the grid frequency limits by ShineBus as following steps:
1) Select layout “4 Parameter”, select option “Read” as following figure.
Fig.4.6.2
2) Select 15, 16, 19
and 20 option in “Set ID” drop-down list. And click button “Operate” to
read the frequency limits one by one.
Fig.4.6.3
3. Check whether the limits are complied with local grid standards. If not, please reset the limits
by ShineBus. Fill Corresponding values in “Set value” field, not selected option “Read”, and
click button “Operate” to set AC frequency limits one by one. Example as Fig.4.6.4, related
values refer to Table 4.6.1.
Fig.4.6.4
To Next Page
Loading...
