- 25 -
Fig.5.2.5 Screws on control board and COM board
7) Replace the COM board (control board) with new one and screw it back by using the four
screws.
8) Reconnect all the connectors on the board.
9) Assemble remain parts in reverse order of the disassemble procedure.
10) Turn on the DC breaker and reset the inverter’s Model and serial number via ShineBus.
Remember to click the “Set” button to save the modification.
Fig.5.2.6 ShineBus set Model and serial number
The inverter’s model name is made up of PFU1MxSx four sections, the last two sections
should be preset in accordance with the power level and country or grid standards. The
meaning of Mx and Sx are shown in Table 5.2.1-5.2.2.
Product Mx
Growatt 10000UE 2
Growatt 12000UE 3
Growatt 18000UE 5
To Next Page
Loading...
