- 3 -
2. If it prompts that the battery is too low after use, please charge it before storing it. Otherwise, long-term storage with low power may
cause damage to the battery inside the product. If the machine's battery is seriously low and idle for too long, the battery will enter
deep sleep mode. To wake the battery from deep sleep, please recharge the portable power station.
3. It is prohibited to place the machine near a heat source, such as in a car under direct sunlight, next to a fire source, or a heating stove.
4. It's important to keep the environment where the machine is stored dry. Never put the machine in water or in places where there's a
possibility of water leakage. To prolong the battery life, when storing for a long time, make sure the power is between 30% and 80%.
Turn off the main switch and keep the machine indoors. It's recommended to charge it to 80% every three months.
5. Never transport a machine with a battery charge higher than 30% by air.
III. Disposal Guide
1. Be sure to completely discharge the machine battery before placing the machine battery in the proper disposal location as per local
rules and regulations. Batteries are hazardous chemicals and should not be disposed of in ordinary trash cans. Follow local laws and
regulations for battery recycling and disposal.
2. If the product itself fails and the battery cannot be fully discharged, please do not dispose of the battery directly in the battery recycling
box. Contact a professional battery recycling company for further processing.
3. Please dispose of overcharged batteries
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
ISED Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure,
users can obtain Canadian
To Next Page
Loading...
