40
Wait for the display to go out.
6.9.3.2 Perform troubleshooting on the PV system:
Check all PV strings for the correct open-circuit voltage.
6.9.3.3 After the fault is rectified, restart the inverter:
Turn the DC & AC Disconnect to position "ON".
6.10 Earth Fault Alarm
The inverter complies with AS/NZS 5033.
The installer does not need to perform any additional
actions, as this is already set up.
When the Earth fault occurs,the Red LED will light up.
The buzzer in the inverter will keep ringing unless the fault condition is cleared(This function is o
nly avilable for Australia and New Zealand).
7 Commissioning
DANGER
Do not disconnect the DC connectors under load.
WARNING
Improper operation during the wiring process can cause fatal injury to operator
or unrecoverable damage to the inverter. Only qualified personnel can perform
the wiring work.
Damage to the inverter due to moisture and dust penetration
Make sure the cable gland has been tightened firmly.
To Next Page
Loading...
