Growatt SPA 1000TL - 6.3.1 Switch to country table

31
32
The DIP switch is composed of five-digit binary number PINS. The different combination
of the five PINS can represent different model, which is corresponding to the local grid
standard. Each small white PIN has two statuses, when set upward to “ON”, its value
turns to “1”, when set downward, its value turns to “0”. Concerning the matching of
the PIN status and the country safety standard, please refer to the table below:
Caution :
When you setting the DIP, you must turn off AC and battery
breaker to make sure all of the power are off.
Caution:
1. After setting the DIP, please power on the SPA series and
check the model display (show as 6.3.1). If the model display is
match what you want, it means your setting is successful.
2. You need to calibrate the time that the machine is showing
after SPA series starts up.
If the country is set incorrectly, please shut down the
SPA series and set again
DIP switch status
Country/region / regulations
Model display
VDE 0126
GT0XXXXXX1
Queensland
GT0XXXXXX2
As4777
GT0XXXXXX3
42 31
ON
5
42 31
ON
5
42 31
ON
5
CEI 0-21
GT0XXXXXX4
NI_G98
GT0XXXXXX5
XINA1
GT0XXXXXX6
VDE-AR-N 4105
GT0XXXXXX7
G98
GT0XXXXXX8
Norway-EN50438
GT0XXXXXX9
CQC
GT0XXXXXXA
Danmark-EN50438-1
GT0XXXXXXB
Hungary
GT0XXXXXXC
Belgium
GT0XXXXXXD
42 31
ON
5
42 31
ON
5
4
2 31
ON
5
42 31
ON
5
42 31
ON
5
42 31
ON
5
42 31
ON
5
42 31
ON
5
42 31
ON
5
42 31
ON
5
6.3.1 Switch to country table