To Next PageTo Next Page
Need help?Do you have a question about the Grundfos BoosterpaQ PMU 2000 and is the answer not in the manual?
General| Brand | Grundfos |
|---|---|
| Model | BoosterpaQ PMU 2000 |
| Category | Controller |
| Language | English |
Outlines electrical connection requirements, NEC compliance, and supply type.
Steps for priming the system when pumps are flooded.
Steps for priming the system when pumps are not flooded.
Lists common problems encountered during system startup and checks.
Explains indicator lights and output signals for system operation and faults.
Describes how fault conditions are indicated in the system.
Provides examples of PMU alarm displays, conditions, and remedies.
Details how to manually reset faults and restart the PFU 2000 system.
Explains the automatic resetting intervals for faults in the PFU 2000.
Factory DIP switch settings for PFU 2000 on systems with 1-4 pumps.
Factory DIP switch settings for PFU 2000 on systems with 5+ pumps.
Navigates the pump status information on the PMU 2000 LCD.
Navigates the zone status information on the PMU 2000 LCD.
Navigates fault indications on the PMU 2000.
Navigates the settings menu for control parameters.
Details setting up multiple set-points using a clock program.
Explains system friction compensation using progressive influence.
Configures min/medium sequence, on/off band, pump rotation, and time for pump change.
Sets maximum and minimum discharge pressure limits.
Provides examples of PFU 2000 fault indications and causes.
Table showing DIP switch settings for PFU 2000.
Details calculation and requirements for minimum inlet pressure.
