Need help?Do you have a question about the Grundfos CMBE 1-44 and is the answer not in the manual?
General| Model | CMBE 1-44 |
|---|---|
| Max Head | 44 m |
| Max Pressure | 4.4 bar |
| Rated head | 44 m |
| Pumped liquid | Water |
| Maximum operating pressure | 10 bar |
| Enclosure class | IP55 |
| Frequency | 50/60 Hz |
| Housing Material | Stainless Steel |
| Seal Type | Mechanical Seal |
| Fluid Temperature Range | 0°C to +60°C |
| Control | Speed control |
| Pipe connection | G 1 inch |
| Connection Inlet/Outlet | Flanged |
| Pump Type | Multistage centrifugal pump |
Defines installation altitude and its effect on motor output.
Outlines requirements for electrical cable selection and use.
Describes the motor's internal thermal protection against overloading.
Explains the pump's protection against voltage transients.
Lists the connections available on the standard functional module.
Displays terminal assignments for inputs and outputs.
Steps for priming and venting the pump.
Procedure for checking and adjusting diaphragm tank pressure.
Describes the automatic pump stop mechanism for dry running.
Details the function and adjustment of the pressure switch.
Instructions for setting the desired operating pressure setpoint.
Procedures for manually starting and stopping the pump.
Troubleshooting steps when the pump fails to operate.
Troubleshooting steps for unstable pump performance.
Troubleshooting steps when the pump repeatedly stops after restarts.
Troubleshooting steps for reverse pump operation.
Specifies the required supply voltage and frequency.
Information on the motor's overload protection characteristics.
Technical specifications for required cables.
To Next Page