Need help?Do you have a question about the Grundfos CME Series and is the answer not in the manual?
General| Type | Centrifugal Pump |
|---|---|
| Power Supply | Electric |
| Maximum Operating Pressure | 10 bar |
| Housing Material | Stainless steel |
| Impeller Material | Stainless steel |
| Material | Stainless Steel |
| Applications | Water boosting, industrial applications, domestic water supply, irrigation, pressure boosting in buildings |
| Pumped Liquid | Clean water |
| Approvals | CE |
| Seal Type | Mechanical Seal |
| Pressure Rating | PN10 |
Details pumps with a built-in PI controller and options for external sensors.
Describes pumps with a built-in PI controller and pressure sensor for discharge pressure control.
Explains how setpoints and other settings can be configured via control panel or remote.
Instructions on securing the pump to a solid foundation using bolts.
Details the M20 screwed cable entries and included cable glands.
Guidelines for maintaining adequate cooling of the motor and electronics.
Details protection measures against electric shock and indirect contact.
Details the single-phase and three-phase supply voltage requirements and connection.
Explains additional protection measures for single-phase and three-phase motors.
Describes connection terminals for both single and three-phase motors.
Guidelines for selecting and connecting screened signal cables.
Details the electrical connections for E-pumps to sensors and other devices.
Describes the different operating modes like Normal, Stop, Min., Max., and Manual.
Details the various control modes such as constant pressure, flow, temperature, etc.
Describes the standard control panel, its buttons, and indicators.
Explains how to set the desired setpoint using the control panel.
Instructions for starting and stopping the pump using the control panel buttons.
Describes methods for resetting alarms and warnings on the control panel.
Details the R100 remote control and its communication with the pump.
Describes the OPERATION menu of the R100, including setpoint, speed, and alarm settings.
Information on the Grundfos GO Remote for wireless communication and pump control.
To Next Page
