Grundfos CMBE Series User Manual

English (GB)
2
English (GB) Installation and operating instructions
Original installation and operating instructions
CONTENTS
Page
1. General information
3
1.1 Hazard statements
3
1.2 Notes
3
2. Safety instructions
3
3. Intended use
8
3.1 Pumped liquids
8
4. System sizing
8
5. Mechanical installation
8
5.1 Installation altitude
8
6. Electrical connection
9
6.1 Cable requirements
9
6.2 Standard functional module, FM 200
10
7. Starting up the product
12
7.1 Supplement to quick guide
12
7.2 Priming and venting the product
12
7.3 Adjusting the diaphragm tank pressure
12
7.4 Shaft seal run-in
12
8. Control functions
12
8.1 Dry-running protection
12
8.2 Pressure switch
13
9. Setting the product
13
9.1 Operating panel
13
9.2 Setpoint setting
14
9.3 Start/stop of pump
14
9.4 Resetting of fault indications
14
10. Servicing the product
14
10.1 Cable requirements
14
10.2 Megging
14
11. Taking the product out of operation
14
12. Fault finding
15
13. Technical data
16
13.1 Operating conditions
16
13.2 Supply voltage
16
13.3 Overload protection
16
13.4 Cable requirements
16
14. Further product information
17
15. Disposing of the product
17
Read this document
before installing the
product. Installation and
operation must comply
with local regulations
and accepted codes of
good practice.
This appliance can be
used by children aged
from 8 years and above
and persons with
reduced physical,
sensory or mental
capabilities or lack of
experience and
knowledge if they have
been given supervision
or instruction concerning
use of the appliance in a
safe way and
understand the hazards
involved.
Children shall not play
with the appliance.
Cleaning and user
maintenance shall not
be made by children
without supervision.

Grundfos CMBE Series Specifications

General

Brand	Grundfos
Model	CMBE Series
Category	Water Pump
Language	English