Grundfos CR 95 - Order of Assembly for Chambers and Impellers

7.4 Order of assembly for chambers and impellers
The assembly of the pump is illustrated in the following drawings.
Each symbol corresponds to a different chamber.
7.4.1 Standard impellers
Pos. 49 is the standard size impeller.
7.4.2 Impellers with reduced diameter
Pos. 49a is an impeller with reduced diameter, 2/3 of standard size.
Impellers (49a) must be fitted as the last stages which are at the
upper part of the pump stack.
Pos. 49h is an impeller with reduced diameter and a larger front
shroud diameter. These impellers are only fitted in pumps which
also contain impellers (49a) with reduced diameter.
Impeller (49h) must be fitted as first stage of the pump which is
placed just above the inlet part (44). Impellers with pos. 49h can be
identified by having one of the below listed part numbers which is
engraved into the impeller:
• 99549699
• 99547569
• 99553557
• 99553558
• 99553559
• 99553560
3
4
5
6
2
1
7
8
9
10
11
12
4
44
4a
47a
3
3a
47a
48
49b
49
49a
49h
49
49a
49
49a
49
49a
49
49a
3a
48
49b
48
48a
49b
48
48a
48
49b
49b
47a
47g
47g
47a
Stage
2 3 4 5 6 7 8 9 10 11 1211
CR95
5
60 Hz50 Hz
TM068473
23
English (GB)