Grundfos Geo-Flo Universal Pump Controller User Manual

30  Rev. 05JUL2016
Appendix F2: Non-Pressurized Variable Speed Flow Center Submials
.
Submial Data
non-pressurized ow center, variable speed, double pump
Project Name:
Contractor:
Engineer:
Order Number:
Addional Informaon:
Technical Data
Electrical Data Approved Anfreeze
Mounng
Pump Performance Curves
Circulators:
Cabinet:
Tank:
Insulaon:
Valves:
Grundfos UPS26-99 & Magna GEO variable speed (requires controller)
Powder coated galvanized steel
Polyvinyl chloride (PVC)
CFC-free polyurethane foam
1”, 3-way, 4-posion ushing and isolaon/service valve, composite
valve body and spool, NBR seals, stainless steel retaining ring
Max. uid temp.: 140°F [60°C]
Min. uid temp.: 20°F [-7°C]
Max. operang press.: 13 psig [89.6 kPa]
Max. ambient air temp.: 104°F [40°C]
Max. ambient relave humidity: 80%
Propylene Glycol
Methanol
Ethanol
Curves are manufacturer’s reported averages using water at 68°F [20°C].
Flow center is
designed for indoor
installaon only.
Flow center must
be installed in an
upright posion as
shown to the right.
The pump terminal
box should be
located in one of the
following orienta-
ons:
UPS26-99 motor: 230V, 60 Hz, single phase, 2-pole, UL and CSA approved, internal thermal over-
load protecon, insulaon class F, three speed
Magna GEO motor: 208-230V, 50/60 Hz, single phase, 2-pole, ETL
C/US
approved (meets UL and
CSA requirements), electronically protected, insulaon class F, variable speed
GEO-FLO PRODUCTS CORPORATION
905 Williams Park Drive
Bedford, IN 47421 U.S.A.
PH: 812-275-8513; FAX: 812-275-8523
www.geo-o.com
SD 1276 rev. 02JAN2013
Flow (U.S. GPM) [l/s]
Grundfos Magna GEO 32-140 and UPS26-99 (pumps in series)
Pumps operate in series
between these curves*
to maintain flow rate
or temperature diff.
Magna GEO + UPS26-99 (high speed)
Magna GEO (lowest duty cycle -- highest ow/head)
Magna GEO (highest duty cycle -- lowest ow/head)
*UPS26-99 is a constant speed pump; Magna GEO is a variable
speed pump. When both pumps are running, the Magna GEO
operates between duty cycles shown below to maintain
set ow rate or temperature difference.
[0.32 0.63 0.95 1.26 1.58 1.89 2.21 2.52 2.84 3.15]
0 5 10 15 20 25 30 35 40 45 50
0
5
10
15
20
25
30
35
40
45
50
55
60
65
70
75
80
[134]
[15]
[30]
[45]
[60]
[75]
[90]
[105]
[119]
[149]
[164]
[179]
[194]
[209]
[224]
[239]
Head (Feet) [kPa]
*At 230V
UPS26-99
Magna GEO
NP
1
NP
2
NP
V
NP
V2
NP Series

Grundfos Geo-Flo Universal Pump Controller Specifications

General

Brand	Grundfos
Model	Geo-Flo Universal Pump Controller
Category	Controller
Language	English