Grundfos MP 1 / Redi-Flo2 - Pump Operation and Performance; Setting Pump Performance; Minimum Flow Requirements; Post-Operation Procedure

12
10. Dismantling and assembly
10.1 Description and overview of the MP 1/
Redi-Flo2 sampling pump system
Components
Pos. Designation
1 Motor with suction interconnector
74 Filling screw
74a  O-ringforllingscrew
200 Service kit: wear parts including impellers
201a Chamber/pump housing
207 Seal
213 Impeller
215 Strainer
215a Screw
230 Intermediate ring
232 Guide vanes
285 Washer
A Pump with motor
B Converter
When servicing the MP 1/Redi-Flo2 sampling pump, note that the pumped
liquid is often unknown. Therefore, the necessary precautionary measures
must be taken in accordance with local regulations.
All work on the electric parts of the MP 1/Redi-Flo2 sampling pump

If the motor, motor cable, converter or converter cable is defective, please
contact your nearest Eijkelkamp Soil & Water distributor.
A

Fig.11 Pumpwithconverter
Fig. 12 Pump components