Need help?Do you have a question about the Grundfos NB and is the answer not in the manual?
General| Insulation Class | F |
|---|---|
| Pump Type | Centrifugal |
| Frequency | 50 Hz |
| Material | Stainless Steel |
| Seal Type | Mechanical Seal |
| Applications | Water Supply, Pressure Boosting, Irrigation |
| Flange Standard | DIN |
| Impeller Material | Stainless Steel |
| Voltage | Varies depending on model (e.g., 3 x 220-240D/380-415Y V, 3 x 380-415D/660-690Y V) |
Explains hazard symbols and statements used in instructions.
Explains symbols used for important notes and tips.
Describes NB, NBG, and MTB pumps and their applications.
Details how to identify pump models and their components via nameplates.
States pumps are tested before factory dispatch.
Provides warnings and precautions for safely handling and moving the pump.
Guides on checking product conformity, voltage, and for any damage upon receipt.
Advises on proper storage to prevent corrosion or damage.
Instructions for mounting the motor onto pumps without a base frame.
Steps for attaching the motor to pumps with feet.
Specific clearance requirements for vertical pump installations.
Clearance requirements for horizontal pump installations.
Clearance specifications for MTB pump installations.
Instructions and safety precautions for lifting the pump unit.
Shows pump installation orientations and flow direction.
Requirements for preparing a concrete foundation for pumps without base frames.
Guidelines for creating a foundation for pumps with base frames.
Details on installing inlet and outlet pipes without stressing the pump.
Methods to achieve optimal operation and minimize noise and vibration.
Guidance on selecting and using vibration dampers for pump isolation.
Advantages and installation guidelines for expansion joints in piping.
Recommendations for installing pressure gauges for operation monitoring.
Advice on fitting condensation covers for outdoor pump installations.
Requirements for protecting the motor against overload and electric shock.
Details on cable entry holes and connections for MG motors.
Specifies tightening torques for MG motor terminal covers.
Connection requirements for synchronous motors using a CUE frequency converter.
Guidance on operating pumps with frequency converters and potential effects.
Instructions for flushing the pipe system before pump startup.
Procedures for filling and venting the pump with liquid.
Steps to prime the pump in systems with liquid above inlet.
Steps to prime the pump in systems with liquid below inlet.
How to verify the correct direction of pump rotation.
Step-by-step guide for safely starting the pump.
Explanation of the initial run-in period for mechanical shaft seals.
Table showing maximum allowed motor starts per hour based on frame size and poles.
Recommendation to take initial readings for monitoring equipment.
Recommendations for protecting the pump from moisture, dust, and damage during storage.
Procedures for handling and returning contaminated pump products.
Information on how to find and order service kits.
States that the pump is maintenance-free.
Guidance on checking and replacing mechanical shaft seals.
Importance of keeping the motor clean for ventilation.
Instructions for lubricating motor bearings based on motor type and size.
Reminder to apply sealant to plugs during assembly.
Procedures for draining the pump to prevent damage from frost.
Lists common faults, their causes, and remedies for pump operation problems.
Details on ambient temperature, altitude, and liquid temperature limits.
Guidelines on not exceeding the maximum pressure stated on the nameplate.
Importance of minimum inlet pressure to avoid cavitation and its causes.
Constraints on inlet pressure combined with pump pressure.
Prohibition of running the pump against a closed valve.
Risks associated with exceeding the maximum flow rate.
Operating ranges and specifications for different types of shaft seals.
Refers to the motor nameplate for electrical specifications.
Tables showing maximum sound pressure levels for different motor configurations.
Instructions for environmentally sound disposal of the product and its parts.
Table detailing hazardous substances in product components according to China RoHS.
Tables providing force and torque data for cast iron and stainless steel flanges.
To Next Page