English (GB)
10
7. Pump without motor
7.1 Mounting of motor on pump housing
without feet
The pumps are supplied with a transport bracket
protecting the shaft seal during transport. When you
mount the motor, follow the instructions shown in
these drawings.
TM05 3327 1212
TM03 3906 1212
1. Remove the coupling guard and loosen the
set screws in the shaft.
2. Place the pump on the motor.
TM03 3907 1212
TM03 3908 1212
3. Fit and tighten the motor screws to the
correct torque. See below.
4. Remove the nut, washer and transport
bracket.
M8: 12 ± 2.4 Nm
M10: 25 ± 5 Nm
M12: 40 ± 8 Nm
M16: 100 ± 20 Nm
M20: 150 ± 30 Nm
M24: 200 ± 40 Nm
To Next Page
Loading...
